Unfortunately, the only solution for this is to remove the security light from the speedometer or dash. Some vehicles may still illuminate the security light after having the SKIM Cars equipped with SKIM that have had security deleted, you will find the security light may illuminate. SKIM cleared PCM's can also be started with both security and non-security keys. If that signal is found, SKIM security is now activated in the PCM and the computer will now always look for the SKIM module. The computer looks for the SKIM security signal when the key is turned on. ** This service does not work for WIN (Wireless Ignition Node) equipped vehicles. The keyless start systems operate differently and are not part of the SKIM system.Įvery Jeep PCM is capable of SKIM security, even if the vehicle is not equipped. ** Y ou must unplug the SKIM module before installing a PCM that has had the SKIM security cleared. The SKIM module must remain unplugged for the SKIM feature to remain inactive.
If you would like to remove SKIM from a car, w e reprogram the Dodge computers to remove the SKIM feature then rewrite the VIN back to the computer. This will be a permanent solution for PCM replacements that had no start conditions.
You may also have to Reset the SKIM in the PCM if too many attempts were made while diagnosing a failed SKIM module (7 attempt). This service is for the removal of the SKIM security programming found on Chrysler, Dodge and Jeep engine computers. Jeep SKIM (Sentry Key Immobilizer Module) Disable / Resetĭid you recently replace a PCM/ECU only to find that the engine started then died, even after the computer was properly reprogrammed? If so, you may also have a bad SKIM module which would cause the vehicle to not start.
0 kommentar(er)
